Generac-power-systems 009600-5 Manuel d'utilisateur télécharger pdf (Page 9)

Generac

Power Systems, Inc. 7

Section 2 – Operation

PRIMEPACT 66G and 66LP Recreational Vehicle Generators

1.6.4 ENGINE SPECIFICATIONS

Type of Engine

PRIMEPACT 66G/66LP ..............................................GN-480

Cooling Method ........................................................Air-cooled

Rated Horsepower

PRIMEPACT 66G/66LP ........................................16 at 3600

Displacement

PRIMEPACT 66G/66LP..................................................480cc

Compression Ratio........................................................8.6 to 1

Cylinder Block ..........................Aluminum w/Cast Iron Sleeve

Type of Governor ..............................Mechanical, Fixed Speed

Engine Governor Speed ............................................2700 rpm

Air Cleaner ........................Paper Element w/Foam Precleaner

Starter ........................................................12-volt DC Electric

Ignition System ......................Solid-state w/Flywheel Magneto

Recommended Spark Plug

Champion ..................................................................RC12YC

AC....................................................................................R45S

Fram Autolite ......................................................................65

Spark Plug Gap........................................0.030 inch (0.8 mm)

Recommended Min. Battery ............400 Cold Cranking Amps

1.6.5 EMISSIONS COMPLIANCE PERIOD

For nonhandled engines the Emissions Compliance

Period referred to on the Emissions Compliance

Label indicates the number of operating hours for

which the engine has been shown to meet Federal

emission requirements.

• For engines less than 225 cc displacement,

Category C=125 hours, B=250 hours, and A=500

hours.

• For engines of 225 cc or more, Category C=250

hours, B=500 hours, and A=1000 hours.

2.1 GENERATOR CONTROL PANEL

The following features are mounted on the generator

control panel (Figure 2.1):

2.1.1 FUEL PRIMER

Before starting a cold engine (if it has not been start-

ed in more than two weeks), you must press this

switch for approximately ten seconds to bring fuel

from the tank to the fuel pump. This rocker type

switch springs back into its original position when

you release it.

2.1.2 START/STOP SWITCH

To crank and start the engine, hold this switch in the

START position. Release the switch when the engine

starts. To stop an operating engine, press and hold

the switch in the STOP position until the engine shuts

off. The switch center position is the RUN position.

2.1.3 15 AMP FUSE

The fuse protects the engine’s DC control circuit

against electrical overload. If the fuse element has

melted open due to overloading, the engine cannot be

cranked. If you must replace the fuse, use only an

identical 15 amp replacement fuse.

2.1.4 LINE BREAKERS

Protects generator’s AC output circiut against

overload, i.e., prevents unit from exceeding

wattage/amperage capacity. This unit has two 30-amp

breakers.

Figure 2.1 – Typical Control Panel

◆

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Generac-power-systems 009600-5 Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Générateurs Generac-power-systems 009600-5